输送带磨损是输送带使用过程中最常见的现象之一，但是巧妙的做好保养工作可以延长输送带的寿命。为大家介绍几种常见的输送带磨损情况： The wear of conveyor belt is one of the most common phenomena in conveyor belt, but it can prolong the life of conveyor belt. Some common wear and tear conditions are introduced: 1、机架与输送带的摩擦。输送带有时会由于输送机的制造、安装、使用等造成的缺陷，而产生跑偏。当跑偏过多时，输送带与托辊支架、机架接触而造成边胶磨损甚至使输送带翻边。 1. Friction between rack and conveyor belt. The conveyor belt can sometimes result from defects caused by the manufacturing, installation and use of the conveyor, and the running deviation is generated. When too much running, the conveyor belt with the bracket of the bracket, the frame contact and cause the edge glue wear even the conveyor belt. 2、导料槽挡板与输送带的摩擦。挡板对输送带的磨损是一种特殊的磨损，如对挡板的设计方法改进并注意维护，这种磨损几乎可以防止。 2. Friction between guide slot baffle and conveyor belt. The wear of the baffle to the conveyor belt is a special kind of wear, such as the design method of the baffle to improve and pay attention to the maintenance, such wear can be prevented almost. 3、托辊与输送带的摩擦。输送带的下覆盖胶也要受到调心托辊以及前倾槽形托辊的磨擦，在槽形托辊到滚筒的过渡段和输送机弯曲的凸起处都有磨损产生。 3. Friction between roller and conveyor belt. The lower cover glue of the conveyor belt is also subjected to the grinding of the center roller and the front tilting roller, which is caused by the wear and tear in the transition section of the roller to the roller and the bending of the conveyor. 4、清扫器与输送带的摩擦。清扫器对输送带造成的磨损通常是均匀的，但用较硬的钢板作为清扫板时，如果使用方法不当，也会将除污物以外的橡胶切削下来。当清扫器尖和输送带间异物进入时，还会在输送带全长上划出很深的伤痕。 4. Friction between the sweeper and conveyor belt. The abrasion of the sweeper is usually uniform, but when using a hard steel plate as the sweeping plate, if the method is not used properly, the rubber will also be cut away from the dirt. When the sweeper and the conveyor belt are entered, the full length of the conveyor belt will be scratched.