| 输送带使用储存注意事项 |
| 添加时间：2017/7/26 16:37:17 浏览次数： |
| 1、输送带在运输和储存中，应保持清洁，避免阳光直射，雨雪浸淋，防止与酸、碱、油类，有机溶液等影响橡胶质量的物质接触，并距离发热源1米以外。 1, the conveyor belt during transportation and storage, should be kept clean, avoid direct sunlight, rain and snow shower, prevent with acid, alkali, oil, organic solution, affecting the quality of rubber material such as contact and outside heat source 1 meter distance. 2、贮存时库房内温度宜保持在－15℃～＋40℃之间，相对湿度宜保持在50%—80%之间。 2, storage room temperature should be keep between 15 ℃ ~ + 40 ℃, relative humidity should stay between 50% - 80%. 3、贮存中输送带须成卷放置，不得折叠，放置期间应每季翻动一次。 3. The conveyor belt should be rolled and folded in storage, and should be rolled over once every season. 4、输送带运送速度不应大于5.0米/秒，运输块度大，磨损性大的物料和使用固定犁型卸料装置时应尽量采用低速。超出规定速度时，会影响胶带使用寿命。 4. The conveyor speed should not be greater than 5.0 m/s, the transport block should be large, the abrasive material and the fixed plough discharging device should be used as low as possible. When exceeding the specified speed, it will affect the service life of the belt. 5、运输机的传动滚筒直径与输送带布局的关系，传动滚筒的配套以及对托辊槽角的要求，应根据运输机的设计规定，合理选取。 5. The transmission drum diameter of the conveyer is related to the layout of the conveyor belt, the supporting of the driving drum and the requirements of the Angle of the roller groove should be selected according to the design of the conveyor. 6、为减轻物料对交待的冲击与磨损，给料方向应顺胶带的运行方向；物料下落到胶带上的落差应尽量的减小；给料口应避开滚筒或托辊的正上方；胶带受料段应缩短辊间距和采取缓冲措施。为防止刮破胶带，挡料装置、刮板清扫装置和卸料装置与胶带的接触部分应采用硬度适宜的橡胶板，不要采用夹有布层的胶带头。 6. In order to reduce the impact and wear of the material, the direction of the belt should be used in the direction of the material. The drop of material falling to the tape should be minimized. The feeding nozzle should avoid the roller or the roller; The belt should shorten the roll spacing and take buffer measures. In order to prevent scraping tape, the contact part of the retaining device, scraper cleaning device and unloading device should be used in the contact part of the tape. |
| 上一页 输送带磨损有哪几种情况 |
| 下一页 输送带的选型 |
Copyright © 技术支持：遨游网络