| 输送带产品分类 |
| 添加时间：2018/6/27 17:40:43 浏览次数： |
| 输送带产品分类 Product classification of conveyer belt 所有的输送带必须接成环形才能使用，所以输送带接头的好坏直接影响输送带的使用寿命和输送线能否平稳顺畅地运行。一般输送带接头常用方法有机械接头、冷粘接接头、热硫化接头等。 All the conveyer belts must be used in a ring, so the good or bad of the belt joints will directly affect the service life of the conveyer belt and the smooth and smooth operation of the conveyer line. The common methods of conveyor belt joints are mechanical joints, cold adhesive joints, hot vulcanized joints, etc. 输送带机械接头法：一般是指使用皮带扣接头，这种接头方法方便便捷，也比较经济，但是接头的效率低，容易损坏，对输送带产品的使用寿命有一定影响。PVC和PVG整芯阻燃抗静电输送带接头中，一般8级带以下的产品都采用这种接头方法。 Conveyor belt mechanical joint method: generally refers to the use of belt buckle joint, this kind of joint method is convenient and convenient, but also more economical, but the efficiency of the joint is low, easy to damage, and the service life of the conveyor belt has a certain impact. PVC and PVG all core flame retardant and antistatic conveyor belt joints, generally 8 grade with the following products are using this joint method. 输送带冷粘接头法：即采用冷粘粘合剂来进行接头。这种接头办法比机械接头的效率高，也比较经济，应该能够有比较好的接头效果，但是从实践来看，由于工艺条件比较难掌握，另外粘合剂的质量对接头的影响非常大，所以不是很稳定。 Conveyor belt cold bonding method: that is, the use of cold adhesive to carry out joints. This kind of joint method is more efficient and more economical than mechanical joint. It should be able to have better joint effect. But in practice, it is difficult to master the process conditions, and the quality of the adhesive has a great influence on the joint, so it is not very stable. 输送带热硫化接头法：实践证明是最理想的一种接头方法，能够保证高的接头效率，同时也非常稳定，接头寿命也很长，容易掌握。但是存在工艺麻烦、费用高、接头时间长等缺点。 Conveyor belt hot vulcanization joint method: practice proved to be the most ideal kind of joint method, can ensure high joint efficiency, but also very stable, the joint life is very long, easy to master. But there are some disadvantages such as trouble in technology, high cost and long joint time. |
| 上一页 耐高温输送带使用注意事项 |
| 下一页 输送带产品分类 |
Copyright © 技术支持：遨游网络